Primera-technology Signature User Manual

Operator’s ManualFor Use With theSignature® III CD Color Printer orInscripta™ Thermal CD PrinterTwo Carlson Parkway North • Plymouth, MN 55447-4446

1012Figure 6: Attaching the Printer StandMake sure that the Printer Control Cable is routed neatly out the back of the Printer Stand so that itcan be

116. Connect the other end of the Printer Control Cable to the printer’s rear-panel 6-pin mini-DINport.Figure 9: Connecting the Printer Control Cable

12B. Hardware Test1. Load the Input Bin with at least 4-5 CDs and place the output bin in the proper location.Figure 12: Loading CDs2. Press the Sequ

13NOTE TO USERS OF SIGNATURE AND SIGNATURE II CD COLOR PRINTERS:Due to a slight difference in CD Tray length between these earlier models, the instruc

14SECTION 3: INTERPRETING THE LED STATUS LIGHTSThe LED Status Lights, located on Conductor’s front panel, can tell you a lot about what ishappening a

15SECTION 4: MAINTENANCE AND TROUBLESHOOTINGConductor is designed to operate for extended periods of time with very little attention. In fact, noreg

16SECTION 5: TECHNICAL SPECIFICATIONSModel Conductor Printer AutoloaderRobotics Controlled by Primera Technology Signature, Signature II orSignature

17INDEXBinsInput...7, 9, 12, 13Outpu

18Tech Support ...15Tray Sup

2

3© 2000 All rights reserved.Notices: The information in this document is subject to change without notice. NO WARRANTY OFANY KIND IS MADE WITH REGARD

4For Users in Canada: This digital apparatus does not exceed the Class B limits for radio noise fordigital apparatus set out on the Radio Interference

5Table of ContentsSECTION 1: GETTING STARTEDA. Introduction ...

6SECTION 1: GETTING STARTEDA. IntroductionThank you . . .. . . for purchasing a Conductor Printer Autoloader. This device automates the transport o

7Front Panel and TopInk JetCD PrinterRobotic ArmInput BinLED Status LightPick ButtonSequence ButtonPause ButtonControlPanelOutput BinCD Printer TrayFi

8Rear PanelThis illustration shows the input ports found on the rear panel of Conductor:Power Input PortPrinter Control PortControl PortSCSI Port Figu

9SECTION 2: HARDWARE AND CABLE SET-UPA. Connecting the Parts and Interface CablesFollow these steps to integrate your autoloader and printer:1. In t